Technical Data Hypaject MKI
Using the pressure pot principle, pre-mixed resin and catalyst are drawn under vacuum into the machines homogeniser, actively degassed and then dispensed under pressure into the mould cavity.
- Standard 3 & 6 litre capacity homogenisers are complimented by 'special order' sizes, ranging from 0.3 to 30 litre.
- Can inject as little as a cupful of pre-mixed material.
- The homogeneous mixing will eliminate cure profile distortions caused by inaccurate catalysation.
- Injection pressure is controllable.
Specifications
- Incoming air, vacuum level & Injection pressure gauges.
- Injection indicator with injection pressure regulator.
- Internal air driven vacuum generator.
- Remote thumb control switch.
- Operates from 0.7lt/sec (1.5cfm) compressed air supply at 6 bar(90psi).
- Non moving part operation provides low maintenance service
